Dimplex Fan DXUF20T User Manual

Installation and Operating Instructions  
08/35113/0  
Issue 0  
Fan Heaters  
Model(s) : DXUF20T & DXUF30T  
(IP20)  
(see Fig. 3)  
Dimensions  
(millimetres)  
H
W
D
(see Fig. 2)  
236 242 175  
Model(s)  
DXUF20T  
DXUF30T  
Specification  
2.0kW Thermostat & Switch  
3.0kW Thermostat & Switch  
Fig. 1  
IMPORTANT : THESE INSTRUCTIONS SHOULD BE READ CAREFULLYAND RETAINED FOR FUTURE REFERENCE  
NOTE: The fuse cover of a non-rewirable plug must be refitted when  
changing the fuse. Should the cover become lost, the plug must not be  
used until the correct replacement fuse cover is obtained from your  
supplier or by contacting our customer helpline.  
IMPORTANT SAFETYADVICE  
READ THESE INSTRUCTIONS BEFORE USE.  
DO NOT use the heater on deep pile carpets or the long hair  
type of rugs, or less than 750mm (30") away from any  
overhanging surface. Keep combustible materials such as  
drapes and other furnishings clear from the front, sides  
and rear of the heater. Do not use heater to dry your laundry.  
IMPORTANT : The wires in this mains lead are coloured in accordance  
with the following code :  
BLUE :  
BROWN :  
NEUTRAL  
LIVE  
As the colours of the wires in the mains lead may not correspond with  
the coloured markings in your plug, proceed as follows :  
Connect the BROWN wire to the terminal marked ‘L’ or coloured RED.  
Connect the BLUE wire to the terminal marked ‘N’ or coloured BLACK.  
Note : L’ or ‘N’ must not be connected to the EARTH terminal marked  
DO NOT use the heater in the immediate surroundings of a  
bath, a shower or a swimming pool.  
DO NOT place the heater directly below a fixed socket outlet.  
The socket-outlet must be accessible at all times to enable  
the mains plug to be disconnected as quickly as possible.  
E’ or  
or coloured GREEN or GREEN AND YELLOW.  
If in doubt, consult your electrician.  
DO NOT COVER or obstruct the air inlet and outlet openings  
in any way.  
Using the Heater  
The heater must be on a flat stable surface when in use.  
Heat Control - see Fig. 2  
DO NOT operate the heater with the mains lead overhanging  
the front outlet grille.  
-
-
-
-
OFF  
Cool Blow*  
Half heat  
Full heat  
NEVER leave the heater unattended when it is used by or  
near the aged, infirm person’s or children.  
The heater carries the Warning symbol indicating that  
it must not be covered.  
Fig. 2  
The instruction leaflet belongs to the appliance and must  
be kept in a safe place. If changing owners, the leaflet  
must be surrendered to the new owner.  
Thermostat Control - see Fig. 3  
The heat output is controlled by the  
thermostat, according to the room  
temperature.  
IMPORTANT – If the mains lead of this appliance is damaged,  
it must be replaced by the manufacturer or its service  
agent or a similarly qualified person in order to avoid a  
hazard.  
*
Turn the thermostat knob fully clockwise  
to maximum setting initially. When the  
room is warm enough, reduce the setting  
slowly until the heater just clicks off.  
WARNING: In order to avoid a hazard due to inadvertent  
resetting of the thermal cut-out, this appliance must not be  
supplied through an external switching device, such as a  
timer, or connected to a circuit that is regularly switched on  
and off by the utility.  
Fig. 3  
The heater will now cycle on and off to maintain your selected room  
temperature. An audible click may be heard when the thermostat  
operates - this is normal.  
Note : If the heater does not come on when the thermostat is at a low  
setting, this is normally because the room is warmer than the thermostat  
setting and is not a fault.  
Electrical connection  
This heater must be used on an A.C.~ supply only and the voltage  
marked on the heater must correspond to the supply voltage. This heater  
is fitted with a plug incorporating a 13 amp fuse. When replacing the  
fuse, a 13 amp fuse approved by ASTA to BS 1362 must be used.  
If the plug is not suitable for the socket outlets in your home, the plug  
must be cut off and an appropriate one fitted. A plug cut off from a  
mains lead will give a shock hazard if inserted into a 13 amp socket  
elsewhere in the house. To avoid this, it should be disposed of  
immediately.  
* When the heat control is set to ‘  
control to maximum.  
‘ for cool blow, set the thermostat  
Position ‘ ‘ will turn the heater on and off to maintain a temperature of  
*
approximately 5°C.  
 

Craftsman Blower 35879474 User Manual
Crown Boiler Furnace CHB68 112 User Manual
Dacor Cooktop RNCT365 User Manual
Delta Electronics Power Supply LFZ24H User Manual
Dynex Flat Panel Television DX 24L200A12 User Manual
EverFocus Automobile Electronics EZ PLATECAM2 002 User Manual
EverFocus Car Video System EN7519VGA User Manual
Fender Guitar 011 1120 22 User Manual
Geemarc Telephone 4 CID User Manual
GE VCR VG4258 User Manual